Washdose Peri Chemical Dosing System

Add to cart
  • Description
  • More
  • Specifications

Washdose Peri Chemical Dosing System is ideal for smaller launderies. The system can be configurable from 3 to 16 peristaltic pumps. For enhanced accuracy, system could have a built-in flow meter sensor.

An incorporated water powered flush system. Formula and Automatic Formula Selection modes are available for programming the system along with Latched mode options.
CE Compliant 100-240 VAC 50/60 Hz, 2 Amp. Transient voltages typically present at mains supply. Mains supply fluctuations not to exceed ±10%
Fuse 6.3A T 250V (internal, replaceable)
Water Valve Output 30 VDC, 0.5 Amps
Pump Drive Outputs 30 VDC, 1 Amp normal, 2 Amps max
Distributor valve 30 VDC
Power Switch On/off rocker switch main console
Environmental specifications (all system modules)
Altitude Maximum operating altitude 2000 meters (6500 feet)
Internal Ambient Temperature Range 5-40ºC (41-104ºF) For indoor use only
Humidity Maximum relative humidity 80% at up to 30ºC (86ºF) decreasing linearly to 50% relative humidity at 40ºC (104ºF)
Pollution Degree 2
Installation Category II
Water supply specifications Recommended flow rate Min: 2 L/min, Max: 10 L/min
Pressure Min: 1 Bar, Max: 4 Bar (dynamic)
Temperature 10-40ºC (50 - 104°F)
Connection BSP 3/4'' female
H and S Series Peristaltic Pumps · Three rollers, self-priming, self-checking
Transport Tubing 12x18 mm PVC reinforce
Nominal Flowrate 1666 ml/min (56.3 oz./min) with H pumps, with standard tubing 9.6x15.9 mm (0.25”) or 416 ml/min (14 oz./min) with S pumps with standard tubing 6.4x12.7mm (0.25”) with water @ 20°
Maximum Suction Tube Length The max length of the suction tube is 5 meters (16 feet). Long tube runs in combination with viscous products shorten pump tube life. It is recommended to keep pick-up lines short as possible and stay within the specification.
Duty Cycle 60% with the maximum continuous run time of 10 minutes