Directions for Use:
Read and understand the MSDS before use.
Always pre-test in an inconspicuous location for sensitivity to chemicals.
Preparation:
– New tile, stone and grout must be fully cured before application of Tile & Grout Sealer Pro (Min 48 hours).
Existing stone, tile and grout must be totally clean, dry and chemical free.
Do not apply in direct sunlight. Apply at temperatures between 10°C and 28°C.
Coverage is 5 to 20m2 / Litre per coat. The coverage for the 2nd coat is dramatically greater.
Application:
Apply 1 to 2 coats of Tile & Grout Sealer Pro by generously saturating the surface using a polish applicator, roller or sprayer to an area which can be easily reached. (Approximately 15m2). Ensure even coverage.
The surface must be shiny wet with a liquid film for at least 1 minute. For very porous substrates more sealer may need to be applied.
Allow 5 – 10 minutes for the sealer to absorb into the surface and then move the excess product with a squeegee to a new section.
If a second coat is to be applied, wait 20 to 30 minutes and repeat the process.
Using absorbent toweling or applicator, wipe off any sealer remaining on the surface after 10 minutes of the last application. Moisten the towel with Methylated Spirits to remove residues which have dried on the surface.
Allow 6 hours before returning area to traffic. Keep dry for 12 hours. Achieves a full cure in 24-48 hours.
Safety
Non-hazardous according to the criteria of NOHSC.
Observe all safety recommendations made on the MSDS and product label.
