INSTALLATION
Install spout and sensor housing to vanity deck with anti-rotation kit escutcheon flange, rubber washers and basin nut (supplied) through 28.5mm Dia mounting hole and 4mm Dia adjacent hole for anti-rotation pin
of escutcheon flange. Mount pump/control housing with bottle support bracket to convenient structure under vanity within 610mm of shank bottom with two (2) screws and wall anchors (supplied). Connect flex
tubing from dispenser shank to fitting on top of pump/control module. Connect spout control cable plug into control unit inline cable connector. Mount battery compartment in convenient location under vanity deck with two (2) screws and wall anchors (supplied) within easy reach of extension cable length and plug connector into mating inline power connector. Plug AC Adapter into power outlet located under vanity within 412cm of pump/control housing and plug connector into mating inline power connector. See OM & IG provided in box with unit for complete installation details.
OPERATION
System shall operate each time an object is positioned within the sensing range of 30mm to 100mm ± 10mm directly in front of the spout of the dispenser. A stream of appropriate viscosity non-abrasive liquid soap drops with total dispense amount of 0.8ml will be pumped from the nozzle during each activation. Optional remote control unit Model № 0390-R (supplied {one (1) per six (6) pack} or order separately) will allow owner
programming of alternate dispense amounts and simplify priming when refilling soap container for initial setup and soap-out conditions. See Model № 0390-R Spec Sheet and Owner’s Manual for complete description of functions. Unit will dispense soap while AC adapter is connected and correct viscosity soap is present in the tank and system is correctly maintained to enable dispensing (LED is not flashing continuously or does not remain dark when trigger attempt is made). LED will display flash for sensing. Manual priming fill button on pump runs motor (or use 0390-R) for
easy soap priming. Soap is manually replenished on service interval determined by maintenance schedule. See OM & IG for complete description of Features and Operations.
