All exposed surfaces shall be No. 4 satin finish and be protected during shipment with a PVC film easily removable after installation. Towel dispensing slot shall have a fully hemmed-in rolled edge for snag-free dispensing and user safety.
Structural assembly of body and door components shall be of welded construction.
This Surface Mounted Paper Towel Dispenser - Traditional shall be provided with refill viewer slots on each side and shall have internal towel stack guides. The wall below unit shall be protected against uncontrolled door drop by the self-limiting body and hinge construction. Back of unit shall have keyhole slots for hanging on pre-installed screws (by others).
INSTALLATION
The unit is surface mounted on a wall or partitioned using five No. 10 self-tapping screws (supplied by others). Four mounting holes through back are “keyhole” slots for ease of installation on pre-installed screws. Centre top mounting hole is a horizontal slot for ease of adjustment and vandal resistant locking. For mounting height, standards refer to current Building Code of Australia for able-bodied and/or disabled use.
OPERATION
Towels are self-feeding until supply is depleted. The unit may be refilled with a partial load in-place and will continue to feed properly. Low level of towel supply is indicated from 25% capacity empty.